| Output Power | 12V-288 | 24V-576 W |
| Output Current | 6 A |
| Max. Output Current | 10 A |
| Input Voltage | 12-24 Vdc |
| Output Channel | 4 |
| Color | RGBW |
| Dimmable? | No |
| Operating Temperature | -4 ~ 140 °F |
| Casing Color | Silver |
| Material | Aluminum |
| Installment | Surface / Flush Mounted |
| screw holder? | Yes |
| Connection Type | Terminal Block |
| Tactile? | No |
| Use | Indoor / Outdoor |
| LED Indicator | No |
| Length | 3.19 in |
| Width | 2.52 in |
| Height | 0.94 in |
| Weight | 3.17 oz |
It receives PWM (Pulse Width Modulation): each time you add one LED Amplifier, the connecting number of LEDs will be more than double, and numerous amplifiers can be connected. The amplifier receives the attenuated signal of the LED input and amplifies it, sending out 10A (2.5A per channel) per output, allowing you to control multiple runs of RGB and White LED lights with one RGBW LED controller.
With this RGB+W LED amplifier or also known as “data repeater”, you can control up to 288W (12V) - 576W (24V) and 10A (or less) of RGB+WhiteLED Lights per output.
It improves the system with load capacity, and has minimal delay, but it can keep synchronism in cascade. Therefore, they are required when the load capability of the RGB+W LED Controller has exceeded, so they are used to increase the load and extend the signal in linear meters, achieving more homogenous effects and at greater distances without parallel routing cables.
